44 POINT CLEANING, TUNE-UP AND INSPECTION
We will leave you with a detailed report for your records
(Reg. $129.95) FOR ONLY $39.95
(Indoor Unit) Air Handler / Duct Work |
1 |
Check evaporator coil fins and condition |
2 |
Check evaporator cooling coil for restrictions |
3 |
Clean evaporator coil surface if accessible and not impacted |
4 |
Condensate drain pan inspected |
5 |
Condensate drain line blown out or vacuum |
6 |
Add algae tablets condensate drain pan |
7 |
Check condensate overflow safety switches |
8 |
Disinfect interior cabinet insulation and coil |
9 |
Inspect Expansion valve / metering device and blub |
10 |
Check Electric heater, voltage and amperage |
11 |
Test Electric heater air temperature rise |
12 |
Check Blower motor circuit boards |
13 |
Check Blower motor fan relay |
14 |
Check Blower motor run capacitor |
15 |
Test Blower motor amperage draw |
16 |
Verify blower wheel condition and balance |
17 |
Verify all breaker / fuse / wiring sizes to NEC codes |
18 |
Clean or replace Return air filter and advise |
19 |
Test Thermostat / Humidistat operation |
20 |
Check Indoor temperature and relative humidity |
21 |
Verify proper air duct sizes for optimum air flow |
22 |
Visually inspect ductwork, supply and return plenums for any leaks, separations and microbial growth for air quality |
(Outdoor Unit) Condenser |
23 |
Check condenser coil fins and condition |
24 |
Clean outdoor condenser unit |
25 |
Test Compressor run capacitor |
26 |
Test Compressor start capacitor |
27 |
Check Compressor potential relay |
28 |
Run Test Compressor time delay relay |
29 |
Check Compressor contactor relay |
30 |
Test Compressor amperage draw |
31 |
Check Condenser fan motor blade setting and balance |
32 |
Test Condenser fan motor run capacitor |
33 |
Check Condenser fan motor amperage draw |
34 |
Inspect Electrical disconnect wiring and verify voltage |
35 |
Tighten All electrical connections high / low voltage |
36 |
Verify all breaker / fuse / wiring sizes to NEC codes |
37 |
Check Refrigerant pressures to factory specs (freon / puron) |
38 |
Inspect Refrigerant line set and line set cover |
39 |
Check Suction and liquid line temperatures |
40 |
System check to current code |
41 |
Check overall equipment condition |
42 |
Check Heat pump control circuit board (where applicable) |
43 |
Inspect Heat pump suction accumulator (where applicable) |
44 |
Check Heat pump expansion valve (where applicable) |
